Undermount
materials. Thin worktops < 20 mm require
Special dowels are used for screw attach-
an additional lining. A layer of sealant is
ments in worktops made of natural stone
BLANCO‘s special undermount bowls
applied between the rim of the sink and
or composite materials.
and almost all BLANCO inset sinks can
the bottom edge of the worktop. The
be fitted from below in non-water drawing
sink is attached to the worktop by special
worktops in natural stone or composite 014984_2f
supporting elements.
Stainless steel: Undermount bowls
SILGRANIT™ PuraDur™: Undermount bowls
Ceramic: Undermount bowls
Bowls for flushmount and undermount installation
014984_2f
Stainless steel: Undermount sinks
SILGRANIT™ PuraDur™: Undermount sinks
Special supporting elements are required for undermounting inset sinks (see page 357).
In-between module
by screws. Depending on the planning
In-between modules replace the work-
situation, the worktop material is placed
Elevated modules are placed in silicone
top over a defined width. The module is
to the right and left and a layer of sealant
without supporting elements.
placed on the sink cabinet and secured
applied.
Stainless steel: Module in-between
SILGRANIT™ PuraDur™: Module between
Module placed on top
SILGRANIT™ PuraDur™: Module elevated
You will find examples of the installation techniques on pages 40 and 41.
254
Unterbaubecken_Asien_2017.indd 254
09.11.16 10:29